Gauge Panel Comes With:
1ea 600A Shunt Output - 0-50 mv
To prevent damage to instrument, do not
connect AMP to any other power source.
If no reading: Check all connections.
If amp reading is reversed, then reverse
black and white wire connections.
The 50 mv. current drop across the shunt
is measured by the meter.
Install the amp shunt between the positive
battery and the charging/load system.
On the rear of the instrument there are
connecting pins with corresponding numbers.
Use patch cable provided to connect the
instrument to the appropriate shunt and power source. See gauge instructions.
Patch cable may be shortened or lengthened
without affecting accuracy of unit. Using 20-22 gauge stranded wire is recommended.